fourfold analog output 0-10V for DMX512
After setting the DMX-start adress the module recieves 4 consecutive DMX-channels and converts the values into four single 10V-analog output signals. Holding the last values, in case of an DMX failure, can be set with jumpers.
Features:
• DMX512 input opto-insulated
• DMX-protocol detection by signal analysis
• Setting the switching behavior on loss of DMX signal (“hold” or “off”)
• DMX control and fine tune for each output separately
• Linear regulators, no separate EMC protection necessary
• Ready for 35mm DIN rail TS